Manualshelf

User's Manual

ManualsBrandsSamsung Electronics ManualsElectronicsTri-Mode Dual Band Analog/PCS Phone (AMPS/CDMA)
12345678910
2. Place it on the back of the base of the phone with the base of the battery.
3. Push up the battery release latch on the back of the phone while push the battery on the the phone.
Turning your phone on and off
When you're ready to turn on your Samsung Phone, check to see that the charged battery has been installed in
the back of the phone or that you have an external power source(the Rapid Cigarette Lighter Adapter or the
Hands-Free Car Kit).Then, Simply press and hold <END>.
The red light flashes briefly and the banner is displayed, which means you're ready to make a call.
Turning off the phone is just as simple. Press and hold <END> for two seconds. The display will be blank when
the power is off.
Removing your battery.
1. First, turn the power off to avoid losing stored numbers and messages.
2. Push up the battery release latch on the back of the phone and pull it out.
Charging your battery.
You can tell whether or not your battery needs to be recharged just by checking the upper-right corner of your
phone's display, where the battery charge indicator is located. When the battery charge level is low, the battery
icon will blink and the phone will sound a tone.
If you continue to use your phone without recharging and the battery level becomes too low it will turn off
automatically. An alert tone will sound just before the phone turns itself off. If this happens, unfortunately you'll
lose whatever you were just doing. So, watch the indicator and make sure your level is okay.
To charge your battery, you should use the Samsung Travel Adaptor,Rapid Desktop Charger, Travel Charger or
Rapid Cigarette Lighter Adapter from Samsung.
Using the rapid desktop charger.
Should only use the Samsung-approved Travel Adaptor and AC adapter with this Samsung Phone. Using the
wrong one could cause damage.
1. Plug one end of the AC adapter into your phone and the other end into a wall outlet.
2. Insert the battery pack.
The blinking red LED and displaying characters in the LCD on the phone will let you know the battery is being
SCH-A330 (Dual-Band Triple-Mode)