User's Manual

When you’re ready to charge your battery, it is vital that you use only Sprint PCS-approved desktop

chargers and travel chargers. To use the desktop charger provided with your phone:

1.Plug the power cord of the charger into a wall outlet.

2.There are three possible charging configurations.

Choose the one that best suits your needs:

_ Insert the phone (with the battery installed) into the front slot of the charger.

_ Insert a single battery (alone, not attached to the phone) into the rear compartment of the charger.

_ Insert a single battery into the rear compartment and your phone (with battery attached) into the

front compartment.

The LEDs on the front of the charger indicate the following:

_ A red light on the charger lets you know the battery is charging.

_ A green light lets you know that the battery is at least 90 percent charged.

_ A yellow light indicates that the battery is operating at a temperature that is too high or too low, or

that there is a poor connection. Check the phone to make sure it is properly positioned in the charger.

It generally takes about 3 hours to fully recharge a completely discharged battery. With the Sprint

PCS-approved Lilon battery, it is okay to recharge the battery before it becomes completely run

down.

To get the quickest charge for any battery:

_ Turn the phone off.

_ Put the phone with the battery attached, into the front slot of the charger.

_ Do not put a battery into the rear slot of the charger.

_ When two batteries are in the charger, the batteries charge simultaneously, but charging time

increases for both batteries.

_ Leaving batteries in the charger once fully charged will not hurt the batteries.

Entering Text