User's Manual

ManualsBrandsSamsung Electronics ManualsElectronicsTri-Mode Dual-Band Analog/ PCS Phone (AMPS/CDMA)

HHeeaalltthh aanndd SSaaffeettyy IInnffoorrmmaattiioonn

SAR tests are conducted using standard operating

positions specified by the FCC with the phone

transmitting at its highest certified power level in all

tested frequency bands. Although the SAR is

determined at the highest certified power level, the

actual SAR level of the phone while operating can be

well below the maximum value. This is because the

phone is designed to operate at multiple power

levels so as to use only the power required to reach

the network. In general, the closer you are to a

wireless base station antenna, the lower the power

output of the phone.

Before a new model phone is available for sale to

the public, it must be tested and certified to the FCC

that it does not exceed the limit established by the

government-adopted requirement for safe exposure.

The tests are performed in positions and locations

(e.g., at the ear and worn on the body) as required by

the FCC for each model. While there may be

differences between the SAR levels of various

phones and at various positions, they all meet the

government requirement.

The FCC has granted an Equipment Authorization for

this model phone with all reported SAR levels

evaluated as in compliance with the FCC RF exposure

guidelines. SAR information on this model phone is on

file with the FCC and can be found under the Display

Grant section of http://www.fcc.gov/oet/fccid after

searching on FCC ID printed in the label on the phone.

FCC certification information for this model phone is

attached separation paper.

For Body Operation

For typical body worn operation with the back of the phone kept 0.6

inches (1.5 cm) from the body. To maintain compliance with FCC RF

exposure requirements, use only belt-clips, holsters or similar

accessories that maintain a 0.6 inches (1.5 cm) separation distance

between the users's body and the back of the phone, including the

antenna, whether extended or retracted. The use of third party belt-clips

holsters and similar accessories should not contain metallic components

in its assembly. The use of accessories that do not satisfy these

requirements may not copmply with FCC RF exposure requirements,

and should be avoided.

For more Information concerning exposure to radio

frequency signals, see the following websites:

Federal Communications Commission (FCC)

http://www.fcc.gov/rfsafety

Cellular Telecommunications Industry Association (CTIA):

http://www.wow-com.com

U.S.Food and Drug Administration (FDA)

http://www.fda.gov/cdrh/consumer

World Health Organization (WHO)

http://www.who.int/peh-emf/en