S-DAQ User Manual V0.
S-DAQ User Manual [ Revision History ] Version Date V0.1 2015.09.
S-DAQ User Manual 1. Introduction S-DAQ is a device for transferring voltage signal and equipment information to an agent PC through wired/wireless communication. Users are advised to read carefully all manuals provided with the package, to ensure safe and efficient use of S-DAQ unit. This manual explains necessary skills and information for setting up and using S-DAQ.
S-DAQ User Manual 2. S-DAQ Basic Specifications S-DAQ comprises three boards (CPU Board, DAQi Board, RS-232 iiBoard) and each board contains following components. 1) Board Components A. CPU Board : CPU, Power Module, Communication Module (WIFI, LAN) B. DAQ Board : ADC Module(40 Channels), FPGA C. RS-232 Board : RS-232 (9 Channels) 2) Exterior The picture is of the S-DAQ board and case.
S-DAQ User Manual WIFI ADC : 40Channel Power Mini USB FG LED(1,2,3 RS-232 : 9Channel LAN0LAN1 USB Power Switch Figure 2 S-DAQ Front Panel Figure 3 S-DAQ Rear Panel A. Power : 24Vdc supply. B. WIFI : Port for connecting external antenna. C. LAN0, LAN1 : LAN Port for Ethernet communication with other devices using TCP/IP. D. Mini-USB : Developer’s Debug Port. E. USB : used for S-DAQ FW update. F. Power Switch : Power On/Off switch. G. ADC : Receives analogue voltage inputs up to 40 channels. H.
S-DAQ User Manual B. DAQ Board H/W Details ITEM ADC CH INPUT FILTER SAMPLE RATE REFERNCE VOLTAGE ADC CONTROL ISOLATION POWER (1) ISOLATION POWER (2) ISOLATION VOLTAGE ADC I/F CPU I/F FPGA PROGRAMMING SUPPLY POWER (1) SUPPLY POWER (2) SUPPLY POWER (3) Size SPECIFICATION SINGLE 40CH, DIFFERENCIAL 20CH 16BIT MAX +/- 10V 40CH 300KHz LOWPASS FILTER 40CH 1KSPS (NORMAL), 5CH 64KSPS (MAX) 4.096V SPARTAN-6 FPGA SERIES 2W 5V to 7V DC-DC CONVERTER 2W 24V to +/- 12V DC-DC CONVERTER MAX 6500VRMS 1SEC SPI 3.
S-DAQ User Manual D. RS-232 Board H/W Details ITEM ADC CH INPUT FILTER SAMPLE RATE REFERNCE VOLTAGE ADC CONTROL ISOLATION POWER (1) ISOLATION POWER (2) ISOLATION VOLTAGE ADC I/F CPU I/F FPGA PROGRAMMING SUPPLY POWER (1) SUPPLY POWER (2) SUPPLY POWER (3) Size SPECIFICATION SINGLE 40CH, DIFFERENCIAL 20CH 16BIT MAX +/- 10V 40CH 300KHz LOWPASS FILTER 40CH 1KSPS (NORMAL), 5CH 64KSPS (MAX) 4.096V SPARTAN-6 FPGA SERIES 2W 5V to 7V DC-DC CONVERTER 2W 24V to +/- 12V DC-DC CONVERTER MAX 6500VRMS 1SEC SPI 3.
S-DAQ User Manual 2) S-DAQ Connection Check A. Change IP Address for Data PC to 192.168.0.5. B. Power on and confirm LED2 is blinking green. Blinking C. Do a ping test to S-DAQ from Data PC to confirm connection.
S-DAQ User Manual 3) S-DAQ Pin Map 8
S-DAQ User Manual 4. HW Specifications DAQ : Stands for Data Acquisition. General terminology for measurement of analog input/output, digital input/output and digital counter/timer. i RS-232 : Serial type communication interface between PC and devices such as sound coupler and modem.
Federal Communication Statement Commission Interference This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generate, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation Caution : Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device is operation in 5.
