User's Manual

Table Of Contents

We recommend to keep 20cm distance when installing this module.

ii.

This module should not be installed and operating simultaneously with other radio without

additional evaluation or FCC filing.

iii.

The host system should have proper label showing that it "Contains FCC ID : A3LSWL-B70F"

WARNING

Modular installation manual

PAGE 1
Modular installation manual WARNING i. We recommend to keep 20cm distance when installing this module. ii. This module should not be installed and operating simultaneously with other radio without additional evaluation or FCC filing. iii.
PAGE 2
Connecting network Checking Wi-Fi module installation 1 f fOpen the filter cover and check the Wi-Fi Module (①) attached on the panel front. The connection status between the Wi-Fi module and the wireless router can be checked by the Wi-Fi module described next page. f fThe Display Wi-Fi LED is ON when the Wi-Fi module is connected to AP & Internet. f fTo replace the Wi-Fi module(Assembling or disassembling), follow the procedure below.
PAGE 3
Assembling the Wi-Fi module 01 PREPARATION 1 . Push the Wi-Fi module down into a slot and fix the hook on the top. 2 . Connect the wire of the Wi-Fi module. 3 . Close the cover of the sub panel.
PAGE 4
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Caution: Any changes or modifications to the equipment not expressly approved by the party responsible for compliance could void user’s authority to operate the equipment.