User Manual

CHAPTER 8. Security
© SAMSUNG Electronics Co., Ltd.
page 385 of 628
8.3.5 Configuring Web Pass-through
The APC provides the web pass-through function to move to a specific address all the time
when the user uses the web.
Configuration using CLI
[WLAN Configuration]
To configure web pass-through in the WLAN, execute the command as follows:
1) Go to configure  WLAN configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# wlan 1
2) Configure a guest flag (default: disabled).
 guest-flag
WEC8500/configure/wlan 1# guest-flag
3) Go to configure  WLAN  security  layer 3 configuration mode of CLI.
WEC8500/configure/wlan 1# security
WEC8500/configure/wlan 1/security# layer3
WEC8500/configure/wlan 1/security/layer3#
4) Enable the WEB authentication (default: disabled).
 web-policy pass-through
WEC8500/configure/wlan 1/security/layer3# web-policy pass-through
5) Configure the Pre-Authentication ACL.
 pre-auth-acl [ACL]
Parameter
Description
ACL
ACL for occurrence of redirection
6) To change the redirection of the basic captive portal configuration to another address,
configure an overriding URL.
 redirect-URL-override [URL]