User Manual

CHAPTER 9. IP Application

page 424 of 628

[NTP Server Configuration]

The NTP server configuration is as follows:

1) Go to configure mode of CLI.

WEC8500# configure terminal

2) Configure a NTP server.

 ntp server enable: Configures a NTP server.

 no ntp server enable: Disables a NTP server.

[Checking NTP Configuration Status]

To check the status of a NTP client or server, enter the ‘show ntp’ command.

Configuration using Web UI

In the menu bar of <WEC Main window>, select <Configuration> and then select the

<NTP> menu in the sub-menus.

The NTP initial window is shown below.

Figure 228. NTP client configuration

The Enable/Disable of a NTP server can be performed using a radio box.

You can configure polling interval enable/disable of a NTP client and also configure the

polling interval during enabling. The range of polling interval is 3-14.

Click the <Add> or <Delete> button to add or delete a NTP proxy server. Click the <Add>

button to configure a specific ‘Server IP’ or ‘Server DOMAIN NAME’ that will be used by

a NTP proxy.