User's Manual

ManualsBrandsSamsung Electronics ManualsElectronicsBluetooth Module

Version 1.0 Samsung Electronics page 1 of

User manual for WIBT30A (for TV)

1. Introduction

WIBT30A is compliant with IEEE802.15.1. The core chipset is BCM2070X from Broadcom.

2. Hardware Architecture:

2.1 Main Chipset Information

Item Vendor Part Number

MAC/BBP/Radio Transceiver/PA Broadcom BCM2070X

2.2 Circuit Block Diagram

The major internal components and external interfaces of WIBT30A are illustrated in Figure 1-1.

Figure 1-1 WIBT30A Major Components and System Interface

3. Feature

WIBT30A is the 802.15.1 RF Device, that acts as a wireless terminal equipment, which can

communicate with a host device.

- Full support for Bluetooth 2.1 + EDR additional features

• Secure simple pairing(SSP)

• encryption pause resume(EPR)

Summary of content (9 pages)

PAGE 1
User manual for WIBT30A (for TV) 1. Introduction WIBT30A is compliant with IEEE802.15.1. The core chipset is BCM2070X from Broadcom. 2. Hardware Architecture: 2.1 Main Chipset Information Item MAC/BBP/Radio Transceiver/PA Vendor Broadcom Part Number BCM2070X 2.2 Circuit Block Diagram The major internal components and external interfaces of WIBT30A are illustrated in Figure 1-1. Figure 1-1 WIBT30A Major Components and System Interface 3. Feature WIBT30A is the 802.15.
PAGE 2
• enhance inquiry response(EIR) • Link supervision time out(LSTO) • Sniff subrating(SSR) • Erroneous Data(ED) • Packet Boundary flag (PBF) - Integrated RF section • Single-ended, 50 ohm RF interface • Buit-in TX/RX switch functionality • TX class 1 output power capability • -88 dBm RX sensitivity basic rate Version 1.
PAGE 3
Figure 3-1 Receiver RF Specifications (bcm2070X) Version 1.
PAGE 4
Figure 3-2 Receiver RF Specifications (WIBT30A) Version 1.
PAGE 5
Figure 3-3 Transmitter RF Specifications(bcm2070X) Version 1.
PAGE 6
Figure 3-4 Transmitter RF Specifications(WIBT30A) Version 1.
PAGE 7
4. PIN description 5. Installation This radio module must be installed in a device and not allow the user to replace nor modify it. And the location of installation is as follows Figure 5-1. Version 1.
PAGE 8
6. Notice l. This device complies with Part 15 of FCC Rules. Operation is Subject to following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received including interference that cause undesired operation. This equipment has been tested and found to comply within the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 9
IC Statement This Class B digital apparatus complies with Canadian ICES-003. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil num?rique de la classe B est conforme ? la norme NMB-003 du Canada. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.