User's Manual

ManualsBrandsSamsung Electronics ManualsElectronicsBluetooth Module

Version 1.0 Samsung Electronics page 1 of 8

Manual for WIBT30D (for BD-HTS)

1. Introduction

WIBT30D is a Bluetooth module with Bluetooth v2.1+EDR specification. The core chipset is CSR8510 from

CSR.

2. Hardware Architecture:

2.1 Main Chipset Information

Item Vendor Part Number

MAC/BBP/Radio Transceiver/PA CSR CSR8510

2.2 Circuit Block Diagram

The major internal components and external interfaces of

WIBT30D are illustrated in Figure 1-1.

Figure 1-1

WIBT30D Major Components and System Interface

3. Operational Description

WIBT30D is the 802.15.1 RF Device, that acts as a wireless terminal equipment, which can communicate

with a host device.

Bluetooth Transmitter

■

8.0 dBm RF transmit power with level control from

on-chip 6-bit DAC over a dynamic range >30dB

Summary of content (8 pages)

PAGE 1
Manual for WIBT30D (for BD-HTS) 1. Introduction WIBT30D is a Bluetooth module with Bluetooth v2.1+EDR specification. The core chipset is CSR8510 from CSR. 2. Hardware Architecture: 2.1 Main Chipset Information Item MAC/BBP/Radio Transceiver/PA Vendor CSR Part Number CSR8510 2.2 Circuit Block Diagram The major internal components and external interfaces of WIBT30D are illustrated in Figure 1-1. Figure 1-1 WIBT30D Major Components and System Interface 3. Operational Description WIBT30D is the 802.15.
PAGE 2
■ Class 1, Class 2 and Class 3 support without need for external PA or TX/RX switch Bluetooth Receiver ■ Receive sensitivity of -91dBm for basic rate ■ Integrated channel filters ■ Digital demodulator for improved sensitivity and cochannel rejection ■ Real-time digitised RSSI available on HCI interface ■ Fast AGC for enhanced dynamic range ■ Channel classification for AFH Synthesiser ■ Fully integrated synthesiser requires no external VCO varactor diode, resonator or loop filter ■ Compatible with external c
PAGE 3
Version 1.
PAGE 4
Version 1.
PAGE 5
Figure 3-1 Transmitter RF Specifications Figure 3-2 Receiver RF Specifications Version 1.
PAGE 6
4. PIN description 5. Installation This radio module must be installed in a device and not allow the user to replace nor modify it. And the location of installation is as follows Figure 5-1. Version 1.
PAGE 7
6. Notice l. This device complies with Part 15 of FCC Rules. Operation is Subject to following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received including interference that cause undesired operation. This equipment has been tested and found to comply within the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 8
IC Statement This Class B digital apparatus complies with Canadian ICES-003. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil num?rique de la classe B est conforme ? la norme NMB-003 du Canada. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.