User's Manual

Smart

Door Lock

SHN-WDS700

Miscellaneous Information

Reset to Factory Default

Resetting the lock will delete all registered information.

Note:AfterReset,letthesensordetectthemagnettosetthehandtypeagain.

All registered Master and user data will be deleted, and the lock will be reset to default

settings.(Refer to the Program section on Page 15 for default values.)

Press the [Registration] button for 10 sec-

onds.

Successful: Ding dong →Dingding

→Dingding

Enter the current Master PIN Code and press

the [ ] button.

Successful: Ding dong dang

Failed: Ding dong ding dong

Restart Function

Continuing to use the lock without replacing the batteries when required will lead to lock

malfunction. Touching a 9V DC battery to the external power contacts on the under-side of the

Exterior Unit will allow for temporary access (continue touching the battery to the contacts until

the lock is open).

9V Battery Emergency Power

Note:Restartingdoesnotdeleteregisteredinformation.

If there is no response after touching the [Touchscreen],

use a pin to press the [Restart] button on the left of the

external power contact of the Exterior Unit.

Note:Please,beawareofthattherehasbemorethan50mmgapbetweenthedoorframe

and the external power contact to place the 9V battery for temporary access.

Miscellaneous