User's Manual

Smart

Door Lock

SHP-DS510

Installing lock

Outside

Inside

1. Installing the Dead Bolt(E)

1. Before installation

1) Check the faceplate type of your door.

2) Make sure the deabolt directon as shown before

inserting it into a door side.

2. Insert the deadbolt from the side of the door.

3. Fix the deadbolt using two FH+T4X19 screws.

* If there is round strike hole, change the faceplate, and

insert the deadbolt following right side drawing.

2. Installing the Exterior Unit

1. Ensure the Exterior Unit is aligned with the center hole of

the deadbolt and Cut the tailpiece 5mm longer than the

door thickness(refer to the page 31).

2. Attach the exterior unit.

CAUTION: The dead bolt must be in a retracted position.

In case of right-handed door, insert the tailpiece vertically.

In case of left-handed door, insert the tailpiece horizontally.

Left-handed Right-handed

REG

SET