User's Manual

Program Mode

The user data can be registered, changed or deleted by entering the code in the

doorlock after making it the Program Mode.

1. Pressing the [Register] Button (from inside)

Open the battery cover of the indoor unit and

press the [Register] button.

2. Entering the Master Password (from outside)

Enter the current master password or

administrator password. Then press the

[¿] button or place the administrator card.

- The unit returns to the normal mode if the

password is not entered within 10 seconds.

3. Terminating the Program

To terminate the program

mode, press the [Register]

button on the indoor unit or

the [Wake Up] button on the

outdoor unit.

Successful: "Too~~t”

Failed: "Toot~~"

In the program mode,

- If LED nos. 1, 2 and 3 flash → Program code entry standby mode

- If LED nos. 4, 5 and 6 flash → User code or group code entry standby mode

- If LED nos. 7, 8, and flash → User data entry standby mode

- To return to the higher menu → Press the [¿] button.

- Please refer to the error code list (page 34) in case an error is generated.

Toot