User's Manual

20
Registering the User Password (Code 20)
The user password can be 4~12 digits. Up to 250 codes can be registered, including
the card registration.
1. Entering the Code in the Program Mode
When the LED numbers 1, 2 and 3 flash after
the program mode is run, press the code 20
and then the [¿] button.
2. Entering the User Code
When the LED numbers 4, 5 and 6 flash, press
the user code (1~250) and then the [¿] button.
- Valid Entry: The ‘toot, toot’ sound is activated, and
the mode is turned into the password entry
standby mode.
- Invalid Entry: The ‘toot~~ toot, toot’ sound is
activated, and the mode is turned into the program
code entry standby mode.
3. Entering the User Password
When the LED 7, 8 and 9 flash, enter the user
password and then the [¿] button.
- Entered password is displayed on the keypad in
the same order and saved. The unit then turns into
the user code standby mode.
- It is recommended to use the password of at least
6 digits for the security reason (use of 0~9
numeric codes).
Valid Entry: "Too~~t, toot, toot”
Failed: "Toot~~, toot, toot"
Toot, toot
Toot, toot