User's Manual

22
Registering the Temporary Password
(Code 30)
A temporary password can be registered for one time use. The registered temporary
user code and password are deleted after a single use.
1. Entering the Code in the Program Mode
When the LED numbers 1, 2 and 3 flash after the
program mode is run, press the code 30 and then the
[¿] button.
2. Entering the User Code
When the LED numbers 4, 5 and 6 flash, press the user
code (1~250) and then the [¿] button.
- Valid Entry: The ‘toot, toot’ sound is activated, and the mode is
turned into the password entry standby mode.
- Invalid Entry: The ‘toot~~ toot, toot’ sound is activated, and
the mode is turned into the program code entry standby
mode.
3. Entering a Temporary Password
When the LED numbers 7, 8 and 9 flash, enter the
temporary password and then the [¿] button.
- Entered password is displayed on the keypad in the same
order and saved. The unit then turns into the user code
standby mode.
- It is recommended to use the password of at least 6 digits for
the security reason (use of 0~9 numeric codes).
Valid Entry: "Too~~t, toot, toot”
Failed: "Toot~~, toot, toot"
- A temporary password cannot be in the administrator group.
Therefore, the temporary password should be registered in the user code 11 ~ 250.
- A temporary password can be used only once.
Toot, toot