User's Manual

27
Additional Functions
Setting up and Releasing the Passage
Mode (Code 70/71)
The Passage function allows free entrance and exit of the people by maintaining the
door unlocked. It is a convenient when the free access is needed.
Entering the code in the program mode
When the LED numbers 1, 2 and 3 flash after the
program mode is operated, press one of the
following codes and then press the [¿] button.
- Passage mode release: Code 70
- Passage mode setup: Code 71
Setting up Current Time
Since the current time is used to set up the entrance control as well as to record the
entrance/exit history, it must be set up at least once after the product is installed.
- In Passage mode, the doorlock does not operate until the [Register] button on the indoor
unit is pressed or PC connection mode is run.
- The Passage mode is set when the door is opened after the outdoor unit handle is
turned without any keypad entry or card contact.
Valid Entry: "Too~~t"
Invalid Entry: "Toot~~"
- Please pay attention to security when in the Passage mode, since the door is not
automatically locked when it is closed.
W
hen the LED numbers 1, 2 and 3 flash
after the program mode is operated,
press code 80 and then the [¿] button.
Enter the year, month, day, hour and
minute in two digits each for total of 10
digits and then press the [¿] button.
Ex) 2009/03/16 01:45 PM => Enter 0903161345
Toot, toot
Valid Entry:
"Too~~t, toot, toot
”
Invalid Entry:
"Toot~~, toot, toot
"