User's Guide

Installation & Methods
MBTS
35463.DOC Samsung Telecommunications America Wireless Systems Lab
ID: Rev: Confidential and Proprietary Page 15 of 32
f. Connect the two-hole power lug to the positive and negative bar and screw the bolt in tight. (See
figure below for correct install.)
Figure 3.1 Power Bus Bar
3.7 T1/E1 I/O Cabling Installation
When installing the T1/E1 cable to the BTS, use CO-type shielded cable provided by the local telephone
utility. The following procedure should be followed to connect the T1/E1 interface cable to the BTS. Figure
3.2 below shows the T1/E1 I/O Cable installation diagram.
3.7.1 Make T1 Connectors
a. Two 24 pins male connectors.
b. 24AWG solder type cables.
c. Two twisted pairs for a T1 connections. One pair for Tx and another pair for Rx.
Figure 3.2 T1 Connector
(For the BTS to operate you need only link 0, but the max number of links you can use are 4.)