User's Manual

Samsung CDMA BSS: Indoor BTS Installation Manual
14
BSS Version 4, Document V4D0001 release 0.5, Indoor BTS Installation Manual, release 2.0
Anchoring the rack on a concrete pad
Lay out and drill the
mounting holes
Lay out and drill mounting holes in the concrete pad as follows:
1 Determine the number and location of the racks.
2 Mark the floor for each rack, using the template shown in the
following illustration:
Be sure to mark the locations of both the anchor bolt holes and the
feet for each rack.
3 Drill the anchor bolt holes for each rack to be anchored.
4 Clean all debris out of the holes before anchoring the racks.
Anchor the rack Anchor the rack to the concrete pad as follows:
1 Obtain 4 anchor bolt assemblies for each rack from the mounting
bracket kits.
2 Set the anchors into the concrete.
3 Position each rack over the marked locations for the feet, being
careful not to damage the feet.