User's Manual

Samsung CDMA BSS: Indoor BTS Installation Manual
21
BSS Version 4, Document V4D0001 release 0.5, Indoor BTS Installation Manual, release 2.0
6 If you removed any drilled floor panels in order to install the anchors,
replace those panels now, with the threaded rods projecting through
the holes in the floor panels.
7 Position each rack over the marked locations for the feet, being
careful not to damage the feet or the anchor bolts.
8 Install the insulating bushing, washer, and hex nut set for each rack
as shown in the following figure:
9 Hand tighten the nuts until leveling and isolation testing is complete.
10 Complete the appropriate boxes in the Indoor BTS Installation
Record.