User's Manual

Samsung CDMA BSS: Indoor BTS Installation Manual
48
BSS Version 4, Document V4D0001 release 0.5, Indoor BTS Installation Manual, release 2.0
If the green LED above a B side shelf circuit breaker does not light,
check the troubleshooting procedure at the end of this chapter.
4 As you apply power to each shelf, the LED on each module on the
right side of that shelf should light.
Note: The LEDs on some modules may stay red, because the BTS is
not transmitting yet.
If the LEDs on all the modules do not light, check the troubleshooting
procedure at the end of this chapter.
Power-up the SDP-T
modules
If all is working so far, proceed to turn on the power modules on the
shelves:
1 Press on the door on the front of the SPD-T module to open the
door.
2 Turn on the power switch for the module. The green LED at the top
of the module should light. If the LED at the top of the module does
not light, check the troubleshooting procedure at the end of this
chapter.