User Manual

Samsung CDMA BSS: Indoor BTS Installation Manual
30
BSS Version 4, Document V4D0001 release 0.5, Indoor BTS Installation Manual, release 2.0
Connecting DC power
Use the following procedure to connect the DC power cables:
1 Verify that the DC power source is off.
2 Connect the power cables to the DC input terminal block. Attach
compression lugs to the input power cables.
3 Check the power switches at the top of the rack to make sure they
are switched off.
4 Check the switches inside the SPD-T modules to be sure they are in
the OFF position.
5 Attach the DC power cables to the noise filters on the top of the rack:
6 Repeat step 3 for SBR2 and SBR3.
7 Label both ends of each cable.
8 Complete the appropriate boxes in the Indoor BTS Installation
Record.