Manualshelf

User Manual

ManualsBrandsSamsung Telecommunications America ManualsElectronicsIndoor BTS
61626364656667686970
CDMA2000 BTS SCBS-519L10 Installation Manual/Ed.01
© SAMSUNG Electronics Co., Ltd. 2-35
2.4.2.3 Anchor Fastening
Fastening Anchor on Raised Floor
Follow the steps below to fasten an anchor on raised floors:
1) Check the holes for rack fastening located on the bottom of the dismounted FAN-P
tray(two on front panel and two on rear panel).
2) Insert an M16 anchor bolt into the drilled hole.
3) Fasten the four corners of the a supporter for preventing earthquake on the anchored
spot.
4) Fasten the supporter on the anchored spot by using the plain washer, spring washer,
and nut.
5) Place four bakelites on the supporter based on the anchoring hole of the spot where the
rack will be placed.
6) Insert the M16 insulation bushing into the placed bakelite to fit the center of the
anchor bolt.
7) Stand the rack and place it upright and slow on top of the anchor bolt.
8) Insert a stud bolt into the frame anchoring hole at the bottom of the rack to be
connected to the bakelites and supporter.
9) Fix the stud bolt on the frame at the bottom of the rack by using the M16 insulation
bushing, plain washer, spring washer, and nuts.
10) Fix the stud bolt at the bottom of the supporter by using the M16 insulation bushing,
plain washer, spring washer, and nuts.
Fastening Anchor on Normal Floor
Follow the steps below to fasten an anchor on normal floors:
1) Check long holes(two on the front, two on the back) for fixing racks at the bottom of
the dismounted FAN-P tray.
2) Insert the M16 anchor bolt into the drilled hole.
3) Place a rubber plate on the floor to fit it into the anchoring hole at the bottom of the
rack.
4) Place four bakelites on the rubber plate based on the anchoring hole where the rack
will be placed.
5) Insert the M16 insulation bushing into the placed bakelite to fit the center of the
anchor bolt.
6) Stand the rack and place it upright and slow on top of the anchor bolt.
7) Fix the rack on the anchor bolt of the frame at the bottom of the rack by using the M16
insulation bushing, plain washer, spring washer, and nuts.