User Manual

English 43
Operations
Auto Fill Water
Pitcher
Press and hold Fridge for 3 seconds to turn this function on. Open
the left door of the fridge, and then insert the water tank. Close
the door and the water tank starts to ll with water up to the
preset level.
To turn the function off, press and hold Fridge again for
3 seconds.
NOTE
• By default, Auto Fill Water Pitcher is disabled. Enable this
function after you have installed the water line.
• If you open the door or push the dispenser lever, this function
is stopped temporarily.
• The Auto Fill Water Pitcher indicators blink if there is a leak.
This may occur because the water tank overows, or the
water-line or water-level sensor fails. If this is the case, follow
these steps.
a. Open the rubber cap and drain water.
b. When draining is complete, the indicators stop blinking and
turn solid.
c. Close the rubber cap.
• If the indicators continue to blink, this might be a system
failure. Contact a local service center.
Untitled-1 43 2019-01-17  11:18:21