Specifications

13
3. Disassembly and Reassembly
3-4 Replacement of Fuse
Parts Explaination Photo Explaination
Fuse
The fuse is located on the noise lter.
1. Disconnect power and remove grille.
2. Replace the fuse.
3. When 20A fuse blows out by the operation
of interlock monitor switch failure, replace
the primary interlock switch, secondary
interlock switch, door sensing switch,
interlock monitor switch and power relay.
4. When the above four switches operate
properly, check if any other part such as the
control circuit board, blower motor or high
voltage transformer is defective.
3-5 Replacement of Drive Motor
Parts Explaination Photo Explaination
Drive
Motor
1. Disconnect power and remove bottom plate
screws(5).
2. Remove bottom plate and disconnect the
turntable motor drive.
3. Remove turntable motor screws(1) and pull
the turntable motor out.
4. When replacing the drive motor, be sure to
remount it in the correct position with the
coupler.
5. Connect all the leads to the drive motor.