Specifications

Samsung Plasma Display | 3 + 15
Samsung LCD Display | 14 + 15
Accessories
100.0
49.5
78.0
482.0 300.0
124.1
STN-L320PB (320PX)
SP-L320PB/S (320PX)
631.6
188.1
51.8
222.8
Stand
Ceiling Mount
Wall Mount
Vertical Mount
CML 500D
(400PX/400PXn/400TXn/460PX/460PXn)
WML
4001D (320PX)
WML
4001D (320PX)
100.0
240.0
100.0
100.0
240.0
100.0
35.0
236.0
85.0 85.0
230.0
234.0
85.0
45.0
282.0
27.5
270.0
232.0
180.0
330.0
45.0
45.045.045.0
85.0
25.5
Components (WMB-4050PS)
 

-2.0˚
15.0˚
Remove the 4 screws on the back of the product.
Insert screw B into the plastic hanger.
1. Fix the product to the wall bracket.
2. Hold the product at the top in the center and pull it
forward (direction of the arrow) to adjust the angle.
(See the figure to the right)
3. You can adjust the bracket angle between -2˚ and 15˚.
Speaker
Wall Bracket Assembly & Wall Bracket & Wall Bracket Angle Adjustment (WMB-4050PS)
Only use the components and accessories shipped with the product.
 

WALL BRKT-PLATE: 1 EA
ASSY -HINGE (LEFT): 1 EA
 

ASSY -HINGE (RIGHT): 1 EA
PLASTIC:
4 EA SCREW: 11 EA SCREW: 4 EA SCREW: 11 EA
 

 

 

 

 

104.0
136.6 80.0
53.8
300.0 582.0
SP-L400PB/S (400PX/400PXn)
18.0˚
22.2
50.3
400.0
520.3
699.2
WMB-4050PS (400PX/400PXn/460PX/460PXn)
14.5˚
2-99.2
2-99.2
2-55.2
2-55.2
21.4
47.9
600.0
120.0
124.4
720.0
VMN4240D (400PX/400PXn/460PX/460PXn)
• Contact a technician for installing the wall bracket.
• Samsung Electronics is not responsible for any damages to the product or harm to customers when the installation is done by the customer.
• This product is intended for installation on cement walls. The product may not be secure when installed on plaster or wood walls.
STN-L403TB (460PX/460PXn)
SP-L460PB/S (460PX/460PXn)
104.0
136.6 80.0
53.8
300.0 582.0
974.0
197.5
61.5
295.0
499.2
STN-323TB (400PX/400PXn/400TXn)
974.0
197.5
61.5
295.0
Check the installation diagram and mark the drill points
on the wall. Use the 5.0 mm bit to drill holes deeper than
35 mm. Fix each anchor in the corresponding hole.
Match each of the brackets and hinge holes to the cor-
responding anchor holes and insert and tighten the 11 A
screws.