User manual

to complete the process, and shut down the PC.

4.4 Using the Secure Erase

Utility

IMPORTANT: The following section assumes that the Secure Erase

Utility has been properly installed. Before proceeding, be sure to

successfully complete the entire Secure Erase Utility installation process

as instructed in the section beginning on page 35.

Starting DOS SSD Application

Warning: The Secure Erase Utility will execute only in IDE/ATA or AHCI

mode. Please check your BIOS settings.

Follow the steps below:

1. Configure the USB Flash Drive as a primary booting device in the

BIOS.

NOTE: If you are not sure how to set up your computer BIOS, please

check the user manual of your computer system or motherboard.

2. Boot the Laptop/PC in DOS mode from the USB Memory device.