Owner's manual

52 Section 2B. Your Device’s Settings
To add a preset message to a text message:
1. While the message is open, position the cursor to
where you would like the preset message to go.
2. Press Menu
(right softkey)
> My Text
.
3. Highlight a message to insert, and press Insert (left
softkey).
To edit a preset message:
䊳 Select an existing preset message and press Menu
> Edit My Text and use the keypad to edit or replace
the message and press . (See “Entering Text”
on page 35.)
To delete a preset message:
1. Select a preset message and press Menu (right
softkey)
> Edit My Text. (The entire message is
highlighted.)
2. Press and hold to delete the message.
Press
Done (left softkey) to complete the deletion, or
press
Cancel (right softkey) to cancel the deletion.
Updating Account Settings
You can request that a notification message be sent
back to your device when a message has been
successfully delivered and also that your callback
number will be attached to the message.
1. From standby mode, press Start > Messaging > Text
Messages.
2. Press Menu > Tools > Options > Account Settings
.
3. Use the navigation key to highlight a field and then
press to check the box.
䡲 Request delivery notifications launches an onscreen
pop-up message to notify you if the last outgoing
message was successfully delivered.
䡲 Always send callback number provides additional
information to the outgoing message by attaching
the number used in the Callback number field.
4. Select the Callback number field, and if desired,
use the keypad to enter a new callback number.
Press and hold to delete the previous
numbers.
5. Press Done (left softkey).
I325.book Page 52 Tuesday, December 11, 2007 11:23 AM