Specifications

Samsung Electronics
2-3
2-3 Wireless Remote Controller Installation
Accessories
1. Remove the receiver & display unit cover by
using the tab on the bottom of it.
2. Open the receiver & display unit.
3. Connect the end of the connector wire to the
receiver & display unit and connect the other
end of the wire to the electrical component box
as shown in figure.
4. Close the receiver & display unit.
5. Secure the receiver & display unit on the wall
with two screws.
6. Reassemble the receiver & display unit cover.
Caution :
•Do NOT keep the receiver & display unit cables with a
220V cable because the remote controller cables have
low voltage.
Caution :
•The optional kits must be installed by an installation specialist.
•Before installing the optional kits, ensure that you have turned
off the main power.
•All optional kits cables should be installed according to the
national wiring rules and you must install them in the wall not
to be touched by users.
Wireless Remote
Controller(1)
Wire Kit
Length : 10m
Battery(2) M4 X 16 Tapped
Screw(2)
Remote Controller
Holder(1)
Receiver &
Display Unit(1)
Cable-Tie(2) Cable Clamp(5) M4 X 16 Tapped
Screw(7)
2-00216A(1)-PR 5/19/01 10:05 AM Page 2-3