Specifications

Outdoor Unit Installation
6
distributor
board
Auxiliary
power S/W
INDOOROUTDOOR
distributor
board
Auxiliary
power S/W
INDOOROUTDOOR
Hole
Drain plug
Base
Drain Hose
Auxiliary Power S/W
Auxiliary power S/W should be installed near indoor unit so
that each access is possible.Main/Outdoor unit power cords
are connected to upper/lower terminal of auxiliary power S/W.
Wiring Connection
Indoor unit connector wire should be connected to both
indoor unit connector and outdoor unit terminal board as
shown in the figure.
Auxiliary Power S/W
Auxiliary power S/W should be installed near indoor unit so
that each access is possible.Main/Outdoor unit power cords are
connected to upper/lower terminal of auxiliary power S/W.
Wiring Connection
Indoor unit connector wire should be connected to both
indoor unit connector and outdoor unit terminal board as
shown in the figure.
Installation of Drain Line
In heating and deice operation, condensed water may be generated.
Install drain line as following procedure.
1. Insert the drain plug into base hole.
2. And then connect drain hose to drain plug.
COOLING ONLY
HEAT PUMP
Installation
44
(18K/ 24K)
(18K/ 24K)
00150A(2)-37~53 2/5/01 11:44 AM Page 44