Product specifications

Troubleshooting

Samsung Electronics26

5-3-7 Room Pipe sensor failure

1. Check the assembly condition of the sensor connector(CN43) on the indoor unit Main PCB and if not assembled, reassemble the

connector accurately.

2. Detach the room pipe sensor connector(CN43) and check the resistance between connector 3 and 4.

If the above data is not met, replace the room pipe sensor.

3. Assemble the room pipe sensor to PCB, plug in, and check the voltage of connector 3 and 4. If the resistance is below 0.5V or

over 4.9V, replace the indoor Main PCB. (short or disconnected in the PCB board)

5-3-8 When the remote control is not receiving.

1. Check if the connector was normally assembled.

2. Put the set in operation and check the voltage of No. 3(+) and No. 2(-) of the main PCB CN91 while operating the

remote control. When the voltage descends below 3V, the assembly module PCB is normal and the main PCB is poor.

Then replace the main PCB.

3. Replace the assembly display PCB because the module PCB is poor if the voltage between No. 2~3 of CN91

maintains 5V after the remote control starts operation.

Temperature(˚C)

Resistance Value(Kohm)

8.31

6.94

5.83

Resistance Value(Kohm)

14.68

12.09

Others

The data tolerance

is ±3%.

Indoor unit heat exchanger temperature sensor error

(open or short)

Description

LAMP

OPERATION TIMER TURBO

: Lamp flickering

: Lamp off

DB98_15924A(3)_1 4/6/04 3:00 PM Page 26