Specifications
13
ENGLISH
mode
Before using good' sleep mode, set the current time.(For setting current time, refer to the page 14.)
For a comfortable sleep, the air conditioner will operate it Fall asleep Sound sleep Wake up from
mode.
1. Press the
button on the remote controller.
indicator appears and Off timer indicator starts blinking on the remote
controller display.
2. Press the
button to set the time.
You can set the time in half hourly unit from 30 minutes ~ 3 hours and hour unit from
3 hours ~ 12 hours.
Operating hour can be set from minimum 30 minutes to maximum
12 hours.
Default operation hour is set to 8 hours.
3. Press the Set/Cancel button to active it.
Off timer indicator stops blinking and reserved time will be displayed for 3 seconds.
Then the air conditioner operates in good’sleep mode.
If you don’t press Set/Cancel button within 10 seconds after pressing the
button, the air conditioner will return to previous status. Check Off
timer indicator and
indicator on the indoor unit.
(However,
will appear for KB series.)
• Set Off timer in mode over 5 hours. You fell disturbed sleep if the is set too short or long
because the default is set to 8-hour-operation.
• If the
mode is set less than 4 hours, the operation will stop at the same time.
If the
mode is set over 5 hours, it will run as Wake up stage from the last one hour before it stops.
• Recommended set temperature is between 25˚C~27˚C for cooling and 21˚C~23˚C for heating.
Temperature and fan speed changes in mode
• Fall asleep: Eases you into sleep by dropping the temperature.
• Sound sleep: Relaxes your body and raises your temperature slightly.
• Wake up from
mode: Allows you to wake up from comfortable intermittent air and it makes you feel refreshed.
When the air conditioner is on and in cool/heat mode
You can set the desired temperature by 1˚C in the range of 16˚C~30˚C.
Fan speed will be adjusted automatically according to the
mode.
However, I f you select
mode while heating operation is on,
you can adjust fan speed.
When the mode is on.
In Cool mode : Air flow direction will be adjusted automatically.
In Heat mode : Adjusting air flow direction is available.
Press the Set/Cancel button once again.Cancel