Specifications
8
Checking the remote controller
Remote controller buttons
• Point the remote controller towards the remote controller receiver of the indoor unit.
• When you properly press the button on the remote controller, you will hear beep sound from the indoor unit and a transmit
indicator(
) appears on the remote controller display.
• When you press [2
nd
F] button, the indicator will be displayed on the remote controller and you can change
the functions on the remote controller as listed below.
d'light Cool Temp/Humi, Auto Clean Beep Off, good’ sleep Display Off, On Timer Time Set function.
If you select the function under the button while the function of the button is switched by 2
nd
F button,
the 2
nd
F function is canceled.
Remote controller display
On Timer
Set the On Timer on.
O Timer
Set the Off Timer on.
Smart Saver
Less energy usage makes your space
cool between the temperature range of
24°C~30°C.
Auto Clean
Auto clean function – Dry inside of the
indoor unit to get rid of odor.
Fan
Adjust how much air flows through the air
conditioner with the 4 different fan speeds
such as Auto/Low/Medium/High.
Set the mode on.
Set/Cancel
Cancel the timer/ mode.
2
nd
F
Switch the function of the button on the
remote controller.
Air swing
Activate/Deactivate air flow blade movement
automatically up and down.
Mode
Set one of the 5 operating modes
(see pages 10~11 for instructions).
Quiet
Reduce noise generated from an indoor unit
during operation.
Power
Turn on/off the air conditioner.
Temp + -
Increase/Decrease the temperature by 1˚C.
d'light Cool
Set the d'light Cool function on/off.
Turbo
Operate in auto fan speed to cool quickly.
SPi
Set the SPi function on/off.
Temp/Humi
• Display the room humidity level and temperature value for 5
seconds on the indoor unit display:
- Hi : High (If the relative humidity is 70% or higher)
- Sd : Standard (If the relative humidity is lower than 70%)
- For room temperature will be displayed the value.
Beep o
To silence the beep sound when pressing the button.
Time set
Set the current time
Display o
To turn off the display light
Before using the functions of the remote controller, you should set the current time. (Refer to p.14)
Only apply to KB series.