Service manual

Press the button for the “ ” mode and the display will be shown as .

Step 3

Reconfirming the option set after completing

Example : 000000-1700b7

7) If the first number is , it is correct. Otherwise, press the button

until appears.

8) When pressing the button ~ on the display, select one of them.

9) When pressing the button ~ on the display, select one of them.

10) When pressing the button ~ on the display, select one of them.

11) When pressing the button ~ on the display, select one of them.

12) When pressing the button ~ on the display, select one of them.

1 Remove the battery from the remote control.

2. Insert the battery into the remote control.

3. Press the (On/Off)button in the direction of the remote control for set.

Step 5

Testing the unit

When pressing the (On/Off)button in the direction of the remote control for unit,

it sounds beep or ringing and the first LED lamp on the left side is flickering at the

same time, then the input option is completed. If it doesn’t sound ringing, try again by

pressing the (On/Off)button.

Step 4

Pressing the (On/Off)button

Error mode

1. If all lamps of the indoor units are flickering, plug out and in again and press the

(On/Off)button again.

2. If the unit doesn’t work properly or all lamps are continuously flickering after setting the option

code, check that the option code is set properly for its own model.

AS07AS(6)MA SM_E_15774 2/12/04 9:19 PM Page 11