Service manual

9
No. Part Procedure Remark
Fan and Motor
Heat Exchanger
Compressor
2
3
4
1) Remove the nut flange
(Turn to the clockwise).
2) Separate the fan.
3) Loosen four screws to separate the motor.
4) Loosen five screws and separate the
motor bracket from the base.
1) Release the refrigerant.
2) Loosen screws of left and right side.
3) Disassemble the inlet and outlet pipe by
welding.
4) Separate the heat exchanger.
1) Release the refrigerant.
2) Open the terminal cover of compressor
and unscrew the connection terminal.
3) Separate the OLP and the compressor
wire.
4) Disassemble the inlet and outlet pipe of
compressor by welding.
5) Loosen three bolts of the lower part.
6) Separate the compressor.
AS07AS(6)MA SM_E_15774 2/17/04 4:38 PM Page 9