OWNER'S INSTRUCTIONS AW0593L AW0693L AW0893L AW1093L AW1293L AW1893L Window-type Room Air Conditioner (Cool) mp. Te r we Po de Mo an ry/F ol/D Co ver E.
Safety Precautions The following safety precautions must be take when installing and using your air conditioner. 1 The air conditioner must be plugged into its own specific power source, which must be installed in conpliance with national wiring , earthing and safety regulations. Depending on national regulations and your specific installation, you may need to install: A circuit breaker For further information on electrical requirements, contact a professional electrician.
Contents PREPARING YOUR AIR CONDITIONER Safety Precautions Description of Each Component .
Description of Each Component The design and shape are subject to change. Air inlet(outside) Outer air flow blades (up/down orientation) - Except AW0593L Inner air flow blades (right/left orientation) Air outlet Ventilation lever - Except AW0593L Air inlet (Inside) Air inlet (Outside) Air filter (Inside) Power plug (The type of power plug may differ, depending on the local power supply.
Remote Control - Buttons and display Remote control transmission indicator Operating mode ( Cool, Dry, Fan) Temperature setting Sleep mode Mode selection button (Cool,Fan, Dry) Temperature adjustment buttons Sleep timer setting button Energy Saving mode Fan speed On Timer setting Off Timer setting Fan speed adjustment button Energy Saving button Timer setting button Timer Set/Cancel button Battery discharge indicator On/Off button E-5
Getting Started You have just purchased a Samsung window-type room air condotioner which should be installed following your installation manual. Your Owner's Instructins contain much valuable information on using your air conditioner. Please tade the tine to read then as they will help you take full advantage of the unit's feaatures. The booklet is organized as follows.
Inserting the Remote Control Batteries You must insert or replace the remote control batteries when : You purchase the air conditioner The remote control does not work correctly Use two AAA, LR03 1.5V batteries. Do not use old batteries or different kinds of batteries together. Batteries may be completely discharged after 12 months, even if they have not actually been used. 1 Push the battery cover on the rear of the remote control with your thumb in the direction of the arrow and remove it.
Using the Control Panel on the Unit p. Tem e Mod Fan er Pow /Dry/ Cool r E.Save Sleep Fan ed Spe er Tim This chapter indicates how to operate and program your air conditioner with the control panel on the unit.
Cooling Your Room You must select the Cool mode if you wish to lower the temperature in your room. You can also set the Fan speed. 1 Press the Result: (On/Off) button. The air conditioner starts up in the cool mode. The unit beeps twice. Control Panel Power The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: Plugged in Stopped It will start up normally after three minutes.
Airing Airing Your Your Room Room If you want to provide air circulation without cooling, you can use the Fan mode. Control Panel Power 1 If necessary, press the Result: (On/Off) button. The air conditioner starts up in the cool mode. The unit beeps twice. 2 If the fan speed(F1, F2 or F3) is not displayed on the control panel: Press the button on the unit one or more times until the fan speed (F1, F2 or F3) is displayed. Mode Cool/Dry/Fan Result: The unit beeps each time you press the button.
Removing Excess Humidity If the atmosphere in your room is very humid or damp,you can remove excess humidity without lowering the room temperature too much. Control Panel 1 If necessary, press the Result: (On/Off) button. The air conditioner starts up in the Cool mode. The unit beeps twice. Power The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: Plugged in Stopped It will start up normally after three minutes.
Setting the On Timer Control Panel Power The On Timer enables you to switch on the air conditioner automatically after a given time, You can select the On Timer only when the air conditioner is off. You can select the On timer when the air conditioner operates in the Cool or Dry mode. 1 Check that the air conditioner has been switched off; if necessary, press the (On/Off) button. 2 Set the operating time by pressing the Timer button on the unit one or more times until the desired time is displayed.
Setting the Off Timer The Off Timer enables you to switch off the air conditioner automatically after a given time. You can select the On timer only when the air conditioner is on. You can select the Off timer when the air conditioner operates in the Cool or Dry mode. 1 Check that the air conditioner has been switched on; if necessary, press the (On/Off) button.
Setting the Sleep Timer The Sleep Timer can be used when your are cooling your room to switch the air conditioner off automatically after 8 hours. If you wish to switch the unit off at a specific time, refer to page 13. Control Panel Power 1 Make sure that you have selected the Cool mode. 2 Press the Result: Cooling button on the unit. Each time you press a button, the unit beeps. The " " will be displayed.
Selecting Energy Saving Mode If the wish to save energy when using your air conditioner, select the energy saving mode. 1 To select the energy saving mode, press the button on the unit one or more times until the Energy Saver indicator lights up. Result: Control Panel The fan and compressor cycle on and off together. The fan will continue to run for a short time after the compressor cycles off. If you would like the air conditioner to run in the Dry mode, do not press the button.
Using the Wireless Remote Control This chapter indicates how to operate and program your air conditioner with the wireless remote control.
Cooling Your Room You must select the Cool mode if you wish to adjust the: Cooling temperature Fan speed when cooling 1 If necessary, press the Result: (On/Off) button. The air conditioner starts up in the Cool mode. The unit beeps. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: Plugged in Stopped lt will start up normally after three minutes.
Airing Your Room If the atmosphere in your room is stale, you can air the room using the Fan feature. 1 If necessary, press the Result: 2 (On/Off) button. The air conditioner starts up in the Cool mode. The unit beeps. If the is not displayed at the top of the remote control, press the button on the remote control one or more times until it appears. Result: The unit beeps each time you press the The air conditioner runs in the Fan mode. The temperature is set automatically. button.
Removing Excess Humidity If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much. 1 If necessary, press the Result: (On/Off) button. The air conditioner starts up in the Cool mode. The unit beeps. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: Plugged in Stopped It will start up normally after three minutes.
Setting the On Timer The On Timer enables you to switch on the air conditioner automatically after a given time.You can select the On timer only when the air conditioner is off. You can select the On timer when the air conditioner operates in the Cool or Dry mode. 1 To set the operating time, press the Timer button one or more times until the required time is displayed. Possible time is between 1 hour and 24 hours inclusive. 2 Press the Result: (Set/Cancel) button to complete the setting.
Setting the Off Timer The Off Timer enables you to switch off the air conditioner automatically after a given time.You can select the On timer only when the air conditioner is off. You can select the Off timer when the air conditioner operates in the Cool or Dry mode. 1 To set the operating time, press the Timer button one or more times until the required time is displayed. Possible time is between 1 hour and 24 hours inclusive. 2 Press the (Set/Cancel) button to complete the setting.
Setting the Sleep Timer The Sleep Timer can be used when you are cooling to switch the air conditioner off automatically after a period of 8 hours. If you wish to switch the unit off at a specific time, refer to page 21. 1 Make sure that you have selected the Cool mode. 2 Press the Result: Cooling button on the remote control. Each time you press a button, the unit beeps. The indicator is displayed. The remaining time is displayed and decreased by 1 hour automatically to indicate the remaining time.
Selecting Energy Saving Mode If you wish to save energy when using your air conditioner, select the energy saving mode. 1 To select the energy saving mode, press the button on the remote control one or more times until the Energy Saving indicator lights up. Result: The fan and compressor cycle on and off together. The fan will continue to run for a short time after the compressor cycles off. If you would like the air conditioner to run in Dry mode, do not press the button.
Adjusting the Air Flow Direction Horizontally Depending on the position of the unit in your room, you can adjust the orientation of the inner air flow blades on the unit. Adjust the air flow blades to the desired position by pushing them side to side. Adjusting the Air Flow Direction Vertically The outer air flow blades can be adjusted to control the vertical air flow direction. (Except AW0593L) RECOMMENDA When... Adjust the blades to face... Cooling Upwards.
Temperature and Humidity R anges The following table indicates the temperature and humidity ranges within which the air conditioner can be used. Mode Indoor Temperature Outdoor Temperature Indoor Humidity C ooling 70 F to 90 F approx. 70 F to 110 F approx. 80% or les s If the air conditioner is us ed at... Then... Higher temperature The automatic protection feature may be triggered and the air conditioner stopped.
Cleaning Your Conditioner Be sure to clean the air filter periodically to maintain the air conditioner in the best condition for a long period of time. When cleaning the air conditioner,turn it off and pull out the power pulg. 1 Open the front grille by pulling the tabs on both sides of the grille. Then lift it up slightly to open the front grille completely. 2 Grab the tabs on the filter and pull it up and out. 3 Remove all dust on the air filter with a vacuum cleaner or brush.
Solving Common Problems Before contacting an authorized service center, perform the following simple checks. They may save you the time and expense of an unnecessary call. Problem Explanation / Solution The air conditioner does not operate at all Check that the circuit breaker used for the air conditioner has not been triggered. Check that the power cable is plugged inot a wall socket and the socket is switched on, if necessary.
SAMSUNG ROOM AIR CONDITIONER LIMITED WARRANTY TO ORIGINAL PURCHASER This SAMSUNG brand product, as supplied and distributed by SAMSUNG ELECTRONICS AMERICA, INC.