دليل المستخدم

setting up your new washing machine _13
01 SETTING UP
STEP 3
Adjusting the levelling feet
When installing your washing machine, ensure that the power plug, the water supply and
the drain are easily accessible.
1. Slide the washing machine into position.
2. Level your washing
machine by turning the
leveling feet in and out as
necessary by hand.
3. When your washing machine is level, tighten the nuts using
the wrench supplied with your washing machine.
STEP 4
Connecting the water and drain
Connecting the water supply hose
1. Take the L-shaped arm fitting for the cold
water supply hose and connect it to the
cold water supply intake on the back of the
machine. Tighten by hand.
The water supply hose must be
connected to the washing machine at
one end and to the water tap at the other.
Do not stretch the water supply hose. If
the hose is too short, replace the hose
with a longer, high pressure hose.
2. Connect the other end of the cold water
supply hose to your sink’s cold water tap
and tighten it by hand. If necessary, you
can reposition the water supply hose at
the washing machine end by loosening the
fitting, rotating the hose, and retightening
the fitting.
For selected models with an additional hot water intake:
1. Take the red L-shaped arm fitting for the hot water supply hose and connect it to the hot
water supply intake on the back of the machine. Tighten by hand.
2. Connect the other end of the hot water supply hose to your sink’s hot water tap and tighten
it by hand.
3. Use a Y-piece if you only want to use cold water.
Hot water supply valve
B1275-02612F_EN.indd 13 2009-5-7 15:04:42