User Manual
7
GB
Setting the Time
Your microwave oven has an inbuilt clock. The time can be displayed in
either the 12-hour or 24-hour notation. You must set the clock:
• When you first install your microwave oven
• After a power failure
✉ Do not forget to reset the clock when you switch to and from
summer or winter time.
Checking that Your Oven is Operating Correctly
The following simple procedure enables you to check that your oven is
working correctly at all times. If you are in doubt, refer to the section
entitled “What to Do if You are in Doubt or Have a Problem” on the page.
✉ The oven must be plugged into an appropriate wall socket. The
turntable must be in position in the oven. If a power level other
than the maximum (100% - 900 W) is used, the water takes
longer to boil.
Open the oven door by pulling the handle on the right side of the door.
Place a glass of water on the turntable. Close the door.
Setting a Standing Time
The Hold Time can be used to set a standing time automatically (without
microwave cooking).
1. To display the time in Then press the Clock
the... button...
12-hour notation Once
24-hour notation Twice
2. Press the
()
and
()
buttons.
3. Press the Clock button.
4. Press the
()
and
()
buttons to set the minute.
5. When the right time is displayed, press the Clock button to
start the clock.
Result:
The time is displayed whenever you are not
using the microwave oven.
Press the
Start
button and set the time to 4 or 5 minutes, by
pressing the
Start
button the appropriate number of times.
Result: The oven heats the water for 4 or 5 minutes.
The water should then be boiling.
1.
Press the
Hold Timer
button.
Result: The following indication isdisplayed :
(Hold/Delay mode)
2.
Set the grilling time by pressing the
10min,1min
and
10s
buttons .
3. Press Start button.
Result:
The oven beeps when the standing time is over.
jXW]niT\UGGwG^GGmSGzG\SGYWWZGG[aZZGwt