Specifications

2
JOHNSON CONTROLS
Form 201.28-NM1.EN.PED/CE (0211)
This equipment is a relatively complicated ap pa ra tus.
Dur ing installation, operation, maintenance or service,
in di vid u als may be exposed to certain com po nents or
conditions in clud ing, but not limited to re frig er ants, oils,
materials un der pressure, rotating com po nents, and both
high and low voltage. Each of these items has the po ten tial,
if misused or handled im prop er ly, to cause bodi ly
injury or death. It is the obligation and re spon si bil i ty of
operating/service per son nel to iden ti fy and rec og nize
these inherent hazards, protect them selves, and pro ceed
safely in completing their tasks. Failure to com ply with
any of these requirements could re sult in se ri ous dam age
to the equipment and the prop er ty in which it is sit u at ed,
as well as severe personal injury or death to them selves
and people at the site.
IMPORTANT!
READ BEFORE PROCEEDING!
GENERAL SAFETY GUIDELINES
This document is intended for use by owner-authorized
operating/service personnel. It is expected that this
in di vid u al possesses independent training that will
en able them to perform their assigned tasks properly
and safe ly. It is essential that, prior to performing any
task on this equipment, this individual shall have read
and un der stood this document and any referenced
materials. This in di vid u al shall also be familiar with and
comply with all ap pli ca ble governmental standards and
regulations per tain ing to the task in question.
SAFETY SYMBOLS
The following symbols are used in this document to alert the reader to areas of potential hazard:
CAUTION identifi es a hazard which could
lead to damage to the ma chine, damage
to other equip ment and/or en vi ron men tal
pollution. Usually an in struc tion will be
given, together with a brief ex pla na tion.
NOTE is used to highlight ad di tion al
information which may be helpful to you.
DANGER indicates an im mi nent ly
hazardous situation which, if not avoid ed,
will re sult in death or se ri ous injury.
WARNING indicates a potentially
haz ard ous sit u a tion which, if not avoid ed,
could result in death or se ri ous in ju ry.
External wiring, unless specifi ed as an optional connection in the man u fac tur er’s prod uct line, is NOT to
be connected inside the Micro Panel cab i net. De vic es such as re lays, switch es, transducers and controls
may NOT be installed inside the panel. NO external wiring is al lowed to be run through the Micro Panel.
All wir ing must be in ac cor dance with Johnson Controls pub lished spec i fi ca tions and must be per formed
ONLY by qual i fi ed Johnson Controls personnel. Johnson Controls will not be re spon si ble for dam ag es/
problems re sult ing from im prop er con nec tions to the con trols or ap pli ca tion of im prop er con trol sig nals.
Failure to fol low this will void the man u fac tur er’s warranty and cause serious dam age to property or
injury to per sons.