Owner manual

Menu overview and advanced features_ 33
5. Press the Test button to verify the LAN connection. When
Connected appears after pressing the Test button, press Next.
If Not connected appears, make sure that the machine is connected
to the network then verify the LAN connection again.
• If a network connection problem persists, contact your
network administrator.
• If you installed an optional fax kit or finisher, press each
Test button for verify connection of them.
6. Enter the IP address, subnet mask, and gateway in each field. Then
press Next.
• If a new IP address is assigned automatically by a DHCP or
BOOTP, press DHCP or BOOTP.
• If you are not sure about your network environment, contact
your network administrator.
7. Press the Name field.
a) The pop-up keyboard appears.
b) The admin is entered as a default. If you want to replace with
another name, remove admin and enter a new administrator
name and then press OK.
c) Press the New Password field. The pop-up keyboard appears.
d) Enter the password to use and then press OK. This password is
to be used for accessing the administrator account.
The password should be at least 8 characters long and it
should be a combination of letters, numbers, and special
characters (except for <,>,”,\).
e) Press the Confirm Pass
word field. The pop up keyboard
appears.
f) Re-enter the password to confirm it, then press OK and Next.
8. Set the time on the machine. You can set the time manually or use
SNTP (Simple Network Time Protocol) to set time automatically
using the time server.
When you press Ma
nu
al:
a) Set the date, time, time offset using the left/right and up/down
arrows.
Example for selecting the time offset: If your local time is 4
hours faster than UTC, press the right arrow until +4 shows.
b) Press Result to check the Manual setting and then press Close.
If necessary, try to set it again.
c) Press Next.
When you press S
NTP (Simple Network Time Protocol):
a) Set the date, time, time offset using the left/right and up/down
arrows.
Example for selecting the time offset: If your local time is 4
hours faster than UTC, press the right arrow until +4 shows.