Service manual

Alignment & Troubleshooting
Service Manual
4-24
Samsung Electronics
Message Meaning Suggested solutions
Not Assigned The speed button or speed dial
number you tried to use has no
number assigned to it.
Enter the number manually using the
number keypad or store the number or
address.
One Page is
Too Large
Single page data exceeds the
configured mail size.
Reduce the resolution and try again.
Open Heat Error
Cycle Power
There is a problem in
the fuser unit.
Turn the power switch off and on. If the
problem persists, call for service.
Operation
Not Assigned
You are in the Add Page/Cancel Job
operation, but there are no jobs
stored.
Check the display to see if there are
any scheduled jobs.
Out-Bin Full The output tray of the machine is full
of paper.
Remove paper.
Over Heat Error
Cycle Power
There is a problem in the fuser unit. Turn the power switch off and on. If the
problem persists, call for service.
Paper Jam 0
Open/Close Door
Paper has jammed in the feeding area
of the tray.
Clear the jam.
Paper Jam 1
Check Inside
Paper has jammed in the paper exit
area.
Clear the jam.
Paper Jam 2
Check Inside
Paper has jammed In the fuser area
or around the toner cartridge
Clear the jam.
Refilled Toner The toner cartridge you have installed
is not genuine or refilled.
The arrow indicates which color toner
cartridge.
The print quality may get poor if the
refilled toner cartridge is installed,
since its characteristics may
significantly differ from the genuine.
We recommend Samsunggenuine
color toner cartridge.
Replace Toner This message appears between Toner
Empty and Toner Low status.
Replace the toner cartridge with a new
one.
Replace
[xxx]
The life of the part expires totally. Replace the part with a new one. Call
for service.
Replace
[xxx] Soon
The life of the part expires soon.
Replace/Install
Toner Waste Bin
The life span of the waste toner tank
has expired and the printer will stop
printing until a new waste toner tank is
placed into the machine.
Replace the waste toner bank with a
new one.
Retry Redial? The machine is waiting for a specified
time interval to redial a previously
busy station.
You can press OK to immediately
redial, or Stop/Clear to cancel the
redial operation.
Scan Unit Open The scan unit is not securely latched. Close the scan unit it locks into place.
Scanner locked The scanner module is locked Turn the power switch off and on. If the
problem persists, call for service.