User manual

20
GB
When the air filter check indicator (FILTER) appears in the display
window after a certain time of use, you should clean the air filter
according to the instructions “Cleaning the Air Filter” on page 20
in this booklet. Then follow the procedure as below if you want to
change the air filter clean time.
1 Hold down PROGRAM LOCK and then press NUMBER 3 pad. Hold
together for 2 seconds.
Result
: The display will show the length of time in hours between
cleaning the air filter you have programmed in or the original time
preset by the manufacturer.
➢ Default clean time is 500 hours in terms of pure oscillating time, not
the continuity time.
2 Press NUMBER pads to set the desired clean time.
➢ You can set up to 999 hours.
3 Hold down PROGRAM LOCK and then press NUMBER 3 pad. Hold
together for 2 seconds in order to save the new value.
This completes the programming of the air filter clean time.
4 Press CANCEL pad to return to cooking mode.
➢ After the clean time has expired, you should clean the air filter.
Programming Air Filter Clean Time
P
P
P
+ 30sec
Cleaning the Air Filter
Clean the Air Filter regularly according to the following
instructions. The oven may have problems when the Air Filter
becomes clogged with dust.
1 Remove the bolt at both ends of the Air Filter.
2 Lift the Air Filter off the post carefully.
3 Wash this filter in warm soapy water.
4 Be sure to replace the Air Filter before using the oven.
➢ If the Air Filter becomes clogged with debris, this will cause an
overheating problem on the oven.
➢ If the want to change the air filter clean time, refer to “Programming
Air Filter Clean Time”.
Care of Your Microwave Oven (continued)
P
+
3
0
s
e
c
Bolt
CM1029-EU-2 2/11/00 5:00 AM Page 20