User manual

I NSTALLATION
8
C
HAPTER T WO : I NSTALLATION
Connecting a VCR
These instructions assume that you have already connected a cable
or antenna to your TV., according to to the instructions beginning on
page 10. If you haven’t, you can skip step 1.
✓ The coaxial, audio and video cables mentioned in the steps below are usually
included with a VCR. You can also purchase them at your local electronics store.
1 Unplug the cable or antenna from the back of the TV.
2 Connect the cable or antenna to the VCR’s ANTENNA IN terminal.
Connect a coaxial cable to the VCR’s ANTENNA OUT terminal.
4 Connect the other end of the cable to the TV’s antenna terminal.
Connect an audio cable to the VCR’s AUDIO OUT terminal.
6 Connect the other end of the cable to the TV’s AUDIO IN terminal.
7
Connect a video cable to the VCR’s VIDEO OUT terminal.
8 Connect the other end of the cable to the TV’s VIDEO IN terminal.
✓ If only one jack (Audio L or R jack) is connected, sound is output from only one
speaker.
✓ If the Audio L/R jacks are connected but the Video jack is not connected, no sound
is output.
✓ When connecting a mono equipment, if the front is connected to Audio L, the back
must be also connected to Audio L. (If differently connected, malfunction may hap-
pen.)
Video Cable
VCR Rear Panel
TV Rear Panel
IN
OUT
ANTENNA
Audio Cable
VCR Rear Panel
TV Rear Panel
IN
OUT
ANTENNA
C
Y
c
✓
1
2
3
4
5
✓
1
2
3
4
5
6
7
8
1
2
3
4
5
Incoming
Cable
VCR Rear Panel
OUT
Coaxial Cable
VCR Rear Panel
IN
OUT
ANTENNA
Coaxial Cable
VCR Rear Panel
TV Rear Panel
IN
OUT
ANTENNA
Audio
Cable
VCR Rear Panel
IN
OUT
ANTENNA
Video
Cable
VCR Rear Panel
IN
OUT
ANTENNA
AA68-00790E(E) 12/6/05 2:22 PM Page 8