Service manual

Samsung Electronics 4-17
Alignment and Adjustment
Note : "XX XX" indicate the previous preset value and adjusted value. Press the START/STOP (Confirm)
button to store the adjusted value.
Caution : For whole zoom range, it shall be in focus. The location of a focus lens is moving depending on
the location of zoom lens. During adjusting, micom measures the focus location from a near dis-
tance to a long.
1) Camera is set to E-E mode.
2) Focus chart photo (the last page of manual)
3) Ensure that camera is left an about 3 m distance from a focus chart and the focus of lens is placed verti-
cally. Attach a focus chart to white or gray wall of a flat surface.
4) Connect a video output terminal to a TV.
5) Press the FF(Mode Up)/REW(Mode Down) button so that OSD shows "ODE XX XX".
6) Press the START/STOP(Confirm) button. Never impact on the lens when adjusting zoom and focus lens.
The OSD shows “OK” after finishing the adjustment.
2. Zoom VR center
1) Camera mode & 3100°K gray scale chart.
2) Connect a video output terminal to a TV.
3) Press the FF(Mode UP)/REW(mode Down) button so that OSD shows “OD6 XX XX”.
4) Press the START/STOP(Confirm) button.
5) Then Micom finds out Zoom VR center position.
Store Zoom VR center value in OB7.
4-2-2 Camera Adjustment
CAMERA ADJ OCD
EPR:XX EVR:XX
(Stored va l u e )
(Adjusted va l u e )
1. LENS ZOOM TRACK
3m +/-1Cm