User guide

MANAGING KEY ASSIGNMENTS

You can view station key assignments and add extenders to some of the pro-

grammable keys for easy one touch operation of frequently used features.

An extender is a number that makes an otherwise general key very specific.

Adding the digit “4” to a PAG E key defines this key for paging zone four. Adding

“225” to a directed pickup key will define this key as pickup for extension 225

only. The key must already be assigned by the installing technician.

Use this program to assign extenders to the following keys:

KEY DESCRIPTION EXTENDER

BOSS .............. Boss/Secretary ................ 1–4

DP ................... Direct Pickup .................... Extension or station group number

DS ................... Direct Station ................... Any extension number

FWRD .............. Call Forwarding .................0–6

GPIK ................ Group Pick-Up .................. 01–20

IG .................... In/Out of Group ................ Any group number you are part of

500–529

MMPG ............. Meet Me Page .................. 0–9, ✱

PSMG .............. Programmed Message ..... 01–20

PAGE ............... Page ................................. 0–9, ✱

SPD ................. Speed Dialing ................... 00–49, 500–999

DIR .................. Directory .......................... PERS (1), SYS (2) or STN (3)

VT.................... Voice Mail Transfer ........... Voice Mail Group (501–529)

PROGRAM KEYS

UP & DOWN - Select the extension number.

KEYPAD - Used to enter extender codes.

HOLD - Used to clear the displayed data.

Open customer programming and follow the instructions below.

ACTION DISPLAY

1. Press TRSF and then dial 107 [201] KEY EXTEND

Display shows the first station 01:CALL1

2. Dial the station number (e.g., 205) OR use [205] KEY EXTEND

UP or DOWN to scroll through the station 01:CALL1

numbers and press the right soft key to

move the cursor

3. Enter the key number (e.g., 18) OR use [205] KEY EXTEND

UP and DOWN to scroll through the keys 18:DS

and use the right soft key to move the

cursor OR press the key to be programmed

4. Dial the extender according to the list

above

and the system will display your

selection

If there are no more entries, press

the left soft key to return to step 2

5. Press TRSF to store and exit programming [205] KEY EXTEND

OR press SPK to store and advance to the 18:DS207

next program