Unit installation

PROSTAR DCS COMPACT INSTALLATION
TECHNICAL MANUAL PART 3 DECEMBER 1994
3–1
PART 3. INSTALLING PRINTED CIRCUIT CARDS
Unpack and inspect each card before installing. Check for signs of physical damage. If
any damage is detected, do not attempt to install. Contact Samsung Technical Support
immediately.
3.1 RAM PACK (Figure 3– 2)
Select the appropriate type of RAM pack for the system. Most systems can utilize a
RAM-1 card; however, systems with Caller ID and those wanting 1500 speed dial
numbers require the RAM-2 card. Make sure that the BACK UP switch is in the OFF
position. Insert the RAM card in the KSU slot labeled RAM (see Figure 3–1). Push firmly
in the middle of the RAM pack to ensure that it is fully inserted into the backplane
connector.
To prevent accidental damage to the RAM card, the RAM connector on the backplane
is positioned to mate only with the RAM card. Other interface cards will not mate with
this connector and the RAM card will not mate with any other connector.
3.2 4 CO PROTECTION CARD (Figure 3– 3)
This card has no selectable options. Insert the 4 CO protection card into the
appropriate slot (see Figure 3–1). Push firmly in the middle of both card ejectors to
ensure that it is fully inserted into the back plane connector.
3.3 2 SLI CARD (Figure 3– 4)
This card has no selectable options. Insert the 2 SLI card into the appropriate slot (see
Figure 3–1). Push firmly in the middle of both card ejectors to ensure that it is fully
inserted into the back plane connector
3.4 MISC 1 CARD (Figure 3– 5)
There are no options to select on this card. Insert the MISC card into the appropriate
slot. Push firmly in the middle of both card ejectors to ensure that it is fully inserted into
the back plane connector.
NOTE: Only one MISC card can be installed in a system.
3.5 MISC 2 CARD (Figure 3– 5)
There are no options to select on this card. Insert the MISC card into the appropriate
slot (see Figure 3–1). Push firmly in the middle of both card ejectors on each card to
ensure that it is fully inserted into the back plane connector.
NOTE: Only one MISC card can be installed in a system.
HOME
PAGE
Table of
Contents