Manualshelf

Unit installation

ManualsBrandsSamsung ManualsConsumer electronicsDCS COMPACT II
21222324252627282930
PROSTAR DCS COMPACT INSTALLATION
TECHNICAL MANUAL PART 6 JANUARY 2002
6–2
When a customer-provided electric door release is installed, cross-connect the
corresponding door release contacts on the DPIM to the door lock mechanism (see
Figures 6–7 and 6–8). Use MMC 501 to program the duration of the contact closure as
required. See the user guides for door lock release operation. The door release
contacts on the DPIM are to be used for low voltage relay control only. The contacts
are rated at 24 VDC-1 amp.
WARNING: Do not attempt to connect commercial AC power to these contacts.
6.6A WALL-MOUNTING KEYSETS
DCS keysets come equipped with a reversible base wedge. To wall-mount a keyset,
remove the wedge from the keyset and remove the directory tray from the wedge.
Mount the wedge to the wall using one of the methods below (see Figure 6–9).
Use screw holes 1 and 2 to attach the base wedge to a standard electrical outlet box.
OR
Use screw holes 1 and 3 to attach to a standard telephone wall-mount plate with
locking pins. This method can cause the keyset to wobble as the keyset feet do not fit
securely to the mounting surface.
OR
Use screw holes 4 and 5 if you are mounting on dry wall with a hole in the middle for
cable access.
6.6B WALL-MOUNTING KEYSETS WITH ULTRA BASE
WEDGE
DCS keysets now come equipped with a new Ultra Base wedge. These base wedges
are reversible and can be used for wall-mounting, however not every wall mounting
scenario is appropriate. First and foremost there is only one keyhole in the center of the
base attaching the wall, and these base wedges can not be used with the standard wall
mount bracket with the two buttons/pins. To wall-mount the keyset using Ultra Base
wedges use screw holes 1, 2 and 3 to mount the base wedge on dry wall with the hole
in the middle for cable access (see Figure 6–10).
6.6C WALL-MOUNTING iDCS KEYSETS
iDCS keysets come equipped with a reversible base wedge. To wall-mount a keyset,
remove the wedge from the keyset and mount the wedge to the wall using one of the
methods below (see Figure 6–11).
HOME
PAGE
Table of
Contents