User guide
TEL E C O M
FOR SAMSUNG TECHNICAL TIPS PLEASE VISIT WWW.PRPTELECOM.CO.UK
CUSTOMISING YOUR KEYSET
Select Ring Tone
You can select one of eight ring tones for your keyset.
1. While on-hook, press the TRSF key and dial 111.
2. Dial a number 18 or press the VOLUME Up and Down keys to hear each tone.
3. When you hear the tone that you want, press the TRSF key.
Change Your Passcode
By default, your extension passcode is 1234. You can change this passcode to any 4-digit number.
1. While on-hook, press the TRSF key and dial 101.
2. Dial your existing (old) passcode.
3. Dial a new passcode (must be four characters, e.g. 3456). You can use numbers 09.
4. Redial the new passcode to verify. If successful, you will hear two beeps. (Four beeps indicate an
invalid code and you should enter the code again.)
5. Press the TRSF key to store the new passcode.
Set Answer Mode
You can receive internal calls in one of three modes: Ringing, Auto Answer or Voice Announce (see
Answering Internal Calls in the section
1. While on-hook, press the TRSF key and dial 103.
2. Dial 0 for Ringing, 1 for Auto Answer or 2 for Voice Announce. (Or use the VOLUME Up/Down keys to
select.)
3. Press the TRSF key to store your selection.
Automatic Hold
While on an outside call, pressing a line key, route key or a flashing CALL key will automatically put your
call on hold and connect you to the next call. This feature can be turned on or off at your keyset.
1. While on-hook, press the TRSF key and dial 110.
2. Dial 001 to turn Automatic Hold on or 000 to turn it off. (Or use the soft keys and VOLUME Up/Down
keys to select.)
3. Press the TRSF key to store your selection.
Headset Operation
You can switch between headset mode and handset mode easily. When using headset mode, you press
the ANS/RLS key to answer and release calls.
1. While on-hook, press the TRSF key and dial 110.
2. Dial 021 to use the headset [Headset Use: On] or 020 to use the handset [Headset Use: Off]. (Or use
the soft keys and VOLUME Up/Down keys to select.)
3. Press the TRSF key to store your selection.
Note: When you are in headset mode, your speakerphone is disabled and the ANS/RLS key will light
steady.