User Manual

ENGLISH

E-13

In the Automatic mode, the room temperature and the fan speed are

controlled automatically.

To select the AUTO mode, press the Mode button until is displayed

at the top of the wired remote controller.

Result:

◆ The air conditioner runs in AUTO mode.

You can change modes at any time.

If necessary, press (ON/OFF) button.

Result:

: ◆

The On/Off indicator on the wired remote controller comes on.

◆ The air conditioner runs in the mode selected when

the unit was last used.

The air conditioner is fitted with a protection mechanism to

prevent the unit from being damaged when it is started

immediately after being:

◆ Plugged in

◆ Stopped

lt will start up normally after three minutes.

IMPORTANT

Selecting the Automatic Operating Mode

To adjust the temperature, press the Temperature buttons one or more times

until the required temperature is displayed. Possible temperatures are between

C and 30

C inclusive.

Result: : ◆

Each time you press Temperature buttons:

- The temperature is adjusted by 1

◆

The air conditioner takes the present temperature of the room

every 30 minutes.

- If the temperature is higher than the selected temperature +

α,

the air conditioner will start cooling.

- If the temperature is lower than the selected temperature -α,

the air conditioner will start heating.

The

is a preset temperature for the most comfortable environ-

ment. It can be adjusted by your installation specialist when

installing the product.