user manual

IR OUT
Receives a signal from the remote control and
outputs the signal through Loopout when a re-
movable sensor board is connected.
CONTROL IN
Connects to the function (Power/Source) control
buttons and receives the light sensor signal and
remote control's IR signal.
DVI OUT (LOOPOUT)
• Connect a monitor to another monitor through
a DVI, DVI to HDMI cable.
• Connect a DVI or DVI-HDMI cable to [DVI
OUT (LOOPOUT)] on the product and [DVI
IN] or [HDMI IN] on another monitor.
• HDMI and network signals sent via the [DVI
OUT(LOOPOUT)] port are displayed on the
second display which has the [DVI IN] port.
Note
• The Loopout function can be used to duplicate
the screen of the primary display. Connect
[DVI OUT] on the primary display to [DVI
IN] or [HDMI] on another display.
• A maximum of 100 monitors can be connec-
ted to DVI-Loopout (using a 2m-long DVI
cable). Up to HD resolution can be supported.
Compatible input sources include DVI IN,
HDMI IN 1, and HDMI IN 2 (MagicInfo).
• The status of the cable may have a great effect
on the Loopout performance.
RGB/COMPONENT IN (PC/COMPONENT
Connection Terminal (Input))
• Connect the [RGB/COMPONENT IN] port
on the monitor to the RGB port on the PC us-
ing the D-SUB cable.
• Connect the [RGB/COMPONENT IN] port
on the monitor to the COMPONENT port on
the external device using the RGB to COM-
PONENT cable.
• Connect the [RGB/COMPONENT IN] port
on the monitor to the BNC port on the PC us-
ing the RGB to BNC cable.
Introduction