user manual
Table Of Contents
- LCD Display
- Safety Instructions
- Introduction
- Connections
- Using the Software
- Adjusting the LCD Display
- Input
- Picture [PC / DVI / DisplayPort / MagicInfo Mode]
- Picture [ AV / HDMI / Component / TV Mode]
- Sound
- Setup
- Multi Control
- MagicInfo
- Troubleshooting
- Specifications
- Information
- Appendix
3. Press SOURCE on the product or remote control and select "AV".
4. Then, start the Camcorders with a tape inserted.
Note
The audio-video cables shown here are usually included with a Camcorder.
(If not, check your local electronics store.)
If your camcorder is stereo, you need to connect a set of two cables.
Connecting Using a HDMI Cable
1. Connect an HDMI cable to [HDMI IN 2 (MAGICINFO)] or [HDMI IN 1] on the
product and the HDMI output port on a digital device.
2. Press SOURCE on the product or remote control and select "HDMI1 / HDMI2"
Note
In HDMI mode, only PCM format audio is supported.
Connections