User manual

setting up your dishwasher _13
CONNECTING THE HOSE
• Connect the appliance to the water mains using a new set of hoses. Do not reuse the old hoses.
Water supply hose
1. Turn off the water supply.
2. Fasten the aqua stop to the inlet connector tightly.
3. Turn on the water supply.
Drain hose
1. If you use only the drain hose for drainage, place and install
it below 80 cm from the ground.
If the drain hose is installed higher than 80 cm, dirty water
may flow back or a significant amount of dirty water may
remain inside the dishwasher.
2. If you are sharing one drain pipe for the draining both the
dishwasher and the sink, connect the drain hose of the
dishwasher to the Y-adapter as shown in the figure below.
Do not install the Y-adapter higher than 80 cm from the
ground. This may result in dirty water flowing back or
a significant amount of dirty water remaining inside the
dishwasher.
01 setting up your dishwasher
Below 80 cm
WARNING
Y-adapter
Below 80
cm
clamp
saddle
WARNING
UserManual-DMS400TH_EN.indd 13 2010-06-01  7:07:01